I need help wiring to the Ranco ETC-111000 Temp Control.
I think I understand this wiring diagram, but just need someone who’s done this to confirm that I doing it correctly, per Figure 4. Don’t want to mess it up and short it out.
LOAD hot wire (black) goes to ‘NO’ terminal.
Jumper (black) goes from ‘NO’ to ‘120’.
Hot wire (black) goes from ‘120’ to POWER
LOAD common (white) goes to ‘COM’, then to POWER.
LOAD is my crockpot
POWER is the electrical power source (plugin).
I think I understand this wiring diagram, but just need someone who’s done this to confirm that I doing it correctly, per Figure 4. Don’t want to mess it up and short it out.
LOAD hot wire (black) goes to ‘NO’ terminal.
Jumper (black) goes from ‘NO’ to ‘120’.
Hot wire (black) goes from ‘120’ to POWER
LOAD common (white) goes to ‘COM’, then to POWER.
LOAD is my crockpot
POWER is the electrical power source (plugin).