Nobody has disassembled a cutter here to provide a picture of the profile of a knife. The knives are not round but lobed. The lobed pull the tobacco into the cutter head where it is sliced.
Last edited:
As long s you don't repeat them.I have a tendency to learn by my mistakes.
Give it your best shot BT, See how running it thru the mill does for the mill. I still love my oldy model. I'll be pissed if I bust it. I have a problem sometimes with the first feed to get it to run and start shredding. Any suggestions. After I get it shredding its fine. I think it has something to do with the sensor to allow the knives to engage.
I took my sensors out the first day I got her. If you use yours a lot you will be Suprised at how much crap builds up on the cutters and wipers.I've had the same problem. I'm suspecting dust on the sensor eye since it sits so long between uses.
Nobody has disassembled a cutter hear to provide a picture of the profile of a knife. The knives are not round but lobed. The lobed pull the tobacco into the cutter head where it is sliced.
I think the cutter is too short after further inspection.
I like to work pro bono, that way I can't get Fired. Always wanted to be a Lawyer, But was raised with morals.Zico really should put you on the payroll BT.